Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Cypress, CA
Chimney repair in Cypress usually starts with a flue inspection, because most homes here were built between 1956 and 1975 and still carry their original clay tile liners. After decades of coastal damp and occasional rain, those liners crack, spall, and pull moisture into the masonry. Hickory Chimney Sweep handles that repair in house, from chimney cap replacement to full relining with DuraFlex liner systems. If you’re seeing rust, efflorescence, or a damper that won’t close, call (855) 554-2841 and we’ll put eyes on it.
Why Cypress Homes Are Different
Cypress reads as a tidy grid of 1960s and 70s tract homes, most built as part of the master-planned push that converted old dairy land into residential streets. The original masonry fireboxes are still in place in a large share of those houses, and they were built with clay flue tiles that were never meant to go fifty years without attention. Homeowners along Valley View, Lincoln, and the side streets off Moody often discover their fireplace has no rain cap at all, which means every wet winter pushes water straight down the flue and into the firebox. The result is usually not heavy creosote, because Cypress gets so few burn nights. It’s rusted dampers, cracked tiles, and spalling brick.
The coastal influence keeps the air damp even when it’s not raining. That marine moisture is hard on masonry, and it is the main reason repairs here lean toward waterproofing, crown work, and liner replacement rather than aggressive sweeping. Homes that were later converted to gas inserts or log sets add another layer: the original clay tile flue often was not sized or prepped for modern gas venting, so the inspection has to check both the masonry condition and the venting path. In Cypress, the job is usually about reawakening a dormant fireplace safely, not just cleaning one that gets used every week.
Styles & brands we work with
Our Main Cypress Services
Most Cypress homeowners call us for one of two reasons: a fireplace that has not been opened in years and needs a full safety inspection and cleaning, or a dryer vent that has never been cleaned since the house was built. Both are fire-safety issues we handle under one roof.
Chimney Sweep in Cypress
A sweep in Cypress starts with the assumption that the flue has not been touched in a decade or more. We check the original clay tile liner for cracks and moisture damage before any brushing happens, because sweeping a compromised flue can make a bad liner worse. The mild climate means most fireplaces here have low creosote, so the critical work is the inspection, the damper check, and the cap or crown condition. For the full scope of what a sweep includes here, see Chimney Sweep in Cypress.
Dryer Vent Cleaning in Cypress
Dryer vents in Cypress’s tract homes often run long distances from the laundry room to an exterior wall, and the original installations were rarely cleaned after construction. Lint builds at every bend and at the termination, and that is a fire hazard that has nothing to do with how often you use the fireplace. We clean the full run, check the exterior termination, and recommend a Famco or Gelco vent cap if the original cover is missing or letting pests in. Full details are on the Dryer Vent Cleaning in Cypress page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Cypress
Chimney repair in Cypress is mostly about water. The original clay tile liners in these 1960s and 70s tract homes absorb moisture from damp marine air and winter rain, then crack when the temperature swings. Once a liner cracks, it can no longer contain heat and combustion gases safely, and the problem compounds fast. That’s why our inspection always includes a camera run through the full flue, so you see the exact condition before anything is recommended. This is the core of the Chimney Repair work we do, and it is done by us, not handed off to a subcontractor.
Chimney Cap Installation
Signs you need it
You see water streaking down the interior firebox wall, hear dripping during rain, or find rust flakes at the base of the flue.
What it costs in Cypress
Chimney cap installation in Cypress typically ranges from $280 to $560, depending on flue size and whether a custom mounting bracket is required.
How we do it
We measure the flue tile opening, select a Copperfield or Gelco cap sized to it, and secure it with a mechanical fastening system so it stays put in Cypress wind and rain.
Chimney Cap Replacement
Signs you need it
The existing cap is rusted through, misshapen from debris impact, or missing entirely, leaving the flue open to rainwater and birds.
What it costs in Cypress
Replacing an old or rusted cap in Cypress runs from $310 to $590, which includes removing the old cap and checking the flue crown underneath.
How we do it
We remove the corroded cap, inspect the exposed flue tile for hidden cracks, then install a new cap that matches the existing flue dimensions.
Chimney Liner Installation
Signs you need it
A camera inspection shows cracked, spalled, or missing sections of clay tile, or you have a gas insert venting into an unlined masonry flue.
What it costs in Cypress
Chimney liner installation for a typical Cypress single-story home ranges from $2,600 to $5,800, depending on liner type and flue length.
How we do it
We size the flue, then install a DuraFlex flexible liner system that is rated for the appliance venting into it, whether wood or gas, and connect it to the termination.
Chimney Flashing Repair
Signs you need it
You see a watermark on the ceiling near the chimney chase, or the flashing metal has lifted, cracked, or separated from the roof line.
What it costs in Cypress
Flashing repair in Cypress typically ranges from $350 to $780, depending on access to the roof penetration and the condition of the surrounding shingles.
How we do it
We remove the failed flashing, assess the underlayment at the penetration, and re-install a stepped flashing assembly sealed against Cypress wet-weather patterns.
Chimney Crown Repair
Signs you need it
The concrete crown at the top of the chimney has visible cracks, is spalling, or has pulled away from the flue tile edges.
What it costs in Cypress
Crown repair or rebuild in Cypress runs from $420 to $1,150, depending on whether a full form-and-pour rebuild is needed.
How we do it
We remove the loose or failed crown material, prepare the surface, and cast a new crown with a proper drip edge that sheds water away from the flue.
What Chimney Repair Costs in Cypress
| Item | Typical range in Cypress |
|---|---|
| Chimney cap installation | $280 – $560 |
| Chimney cap replacement | $310 – $590 |
| Chimney liner installation | $2,600 – $5,800 |
| Chimney flashing repair | $350 – $780 |
| Chimney crown repair | $420 – $1,150 |
Do I need a new chimney liner if I only burn a few times a year?
Not necessarily. You need a camera inspection first. If the clay tile liner is cracked or missing sections, even occasional fires are unsafe, because the liner is your primary containment. If the liner is intact, a cap and crown work may be all you need.
Can you repair a chimney without tearing out the whole masonry stack?
Almost always, yes. HeatShield resurfacing can restore a damaged clay liner from the inside without demolition, and DuraFlex liners can be installed inside the existing flue chase. Full masonry rebuilds are rare in Cypress and only come up after structural failure, not typical water damage.
Brands We Service in Cypress
We stock and install chimney components from Copperfield, DuraFlex, HeatShield, and Gelco, the same professional-grade lines certified chimney contractors specify for relining and termination work. Parts arrive with our crew, not through a hardware-store order. See our brands for what we carry and why it matters.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Cypress, CA
| Service | Typical range in Cypress |
|---|---|
| Chimney sweep (inspection and cleaning) | $180 – $340 |
| Chimney cap installation | $280 – $560 |
| Chimney cap replacement | $310 – $590 |
| Chimney liner installation | $2,600 – $5,800 |
| Chimney flashing repair | $350 – $780 |
| Chimney crown repair | $420 – $1,150 |
Roof pitch and chimney height push cost up in Cypress, especially on two-story homes where ladder and staging access gets tight. We give a flat-price quote before any work begins, and the number we quote is the number you pay.
Neighborhoods We Serve in Cypress
We work throughout 90630, from the tract streets off Lincoln and Valley View to the neighborhoods east of Moody and north toward the 91. Response time for most Cypress calls is one to three business days, depending on the service.
- College Park
- Cypress Village
- Lincoln Park Estates
- Lovelia Park
- Greenbrook
Service Area – Cities Near Cypress
Hickory Chimney Sweep also covers the adjacent communities around Cypress, including La Palma, CA, Los Alamitos, CA, Rossmoor, CA, and Hawaiian Gardens, CA. If you’re in one of the bordering neighborhoods of these cities and the job is urgent, call us and we’ll schedule the visit.
Serving Cypress, CA — Our Local Coverage Area
We’re based in the Cypress area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Cypress
Most Cypress inspections are scheduled within one to three business days. We book a specific arrival window and confirm the day before. If you just bought a home in Cypress and the fireplace was flagged in escrow, we can usually fit that inspection into the same week.
Most chimney repairs like caps, crowns, flashing, and liner work do not require a city permit in Cypress, because they are repairs to an existing fireplace system, not new construction. HOAs in some Cypress developments require matching materials or pre-approval for anything visible from the street, so check your covenants before we schedule exterior work.
Yes. We schedule chimney and dryer vent work together when requested, which saves a second trip charge. One call covers both, and the full visit usually takes under two hours for a standard Cypress tract home with a single fireplace and one laundry room.
If your Cypress fireplace has not been looked at in years, or you already know there is a problem, call (855) 554-2841 for a free estimate. Hickory Chimney Sweep has served Cypress since 2013, and we fix what we find, with the camera evidence to show you exactly what we saw.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Cypress Customers Say
"Weekend rate was higher, which they told me up front and I was fine with. What I wasn't expecting was for someone to actually come out on a Sunday."
— Nathan Pruitt"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
— Beatriz Hernandez"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
— Allen Tran